 |
Carpentry - Real Board Sizes - Woodworking Basics |
|
|
Submitted by Carpenter Joe
| RSS Feed
| Add Comment
| Bookmark Me!
Purchasing material can be confusing, we see terms we are not familiar with, and the material we buy is smaller than we thought, hopefully this page will shed some light on the subject.
Surfaces
The surfaces of a board are refered to as the end, face and edge.
Dimensions
The dimensions are given for the length, width and thickness.
4/4, 5/4, and 6/4 ?
Material will often be listed like this, it simlply means that the thickness of the material is measured in quarter of an inch increments, hence 4/4 is one inch thick, 8/4 is two inches thick.
S4S
This means that the material is finished on all four sides, for example what what we refer to as a 1 X 4 was a piece of rough sawn material 1" thick and 4" wide and is reduced to 3/4" X 3 1/2" when run through a planer.
Lineal Foot
Lumber priced by the linear foot means that you pay for each running foot of the material, prices will increase proportionately for wider or thicker material.
Board Foot
One board foot equals 144 cubic inches of material, prices are usually given per thousand feet. To calculate board feet multiply the width in inches by the thickness in inches by the length in inches and divide by 144.
The advantage to suppliers is that only one price has to be given for each grade and species of material since length and width are covered in the volume calculation.
The chart below gives the board feet in various lengths and widths of material one inch thick, for thicker material multiply by the thickness of the material, always round the thickness up to the next whole inch.
|
|
|
|
|
LinkedIn Recommendation:
 Jonah William - Owner at Tessier Marketing - I thought I was well versed in social media before I found Teo. He has helped me round my skill set with great information only he seems to teach. I went on the web and looked for it later, but it's just not there. The ShareThis.com counters for instance, which definitely don't work right... can't find that anywhere, but it's easy to prove once you know what to test for! Teo really has a way of getting to what works and what works best! - March 17, 2012, Jonah was Teo's client |
|
Featured [Carpentry] Articles:
|
|
